Other Functions - Oner OCT600 User Manual

Vehicle Controls
Command
STP#******
(Stop car）
SK#******
(Enable car moving）

Other Functions

Command
SRT,hh:mm:ss,DD/MM/YYYY#****** To set device real time clock timing, device will adjust the
(RTC setting)
SWTn,h1:m1,h2:m2#******
(Working time setting)
Note: working time feature works according to
GPS time, default GPS time is GMT time ,in
order to make it work correctly
GPS time as local time
(check command timezone setting.page10)
BAL;T;x#******
(SIM balance inquiry)
AUP#******
(Firmware update OTA)
LBSx#******
(LBS Tracking)
SPSx#******
(Power saving mode)
SOOxx00#******
(Engine status report)
Note: "SOOxx00#******","OO"beside "s" is
letter"O", "00"beside"xx"is number zero
ONER GPS Vehicle Tracker
User Manual
Description
******=000000 I.E.：STP#000000
Command (no password):STP
******=000000 I.E.：SK#000000
Command(no password) SK
Description
time according to the clock when there is no gps signal.
******=000000. hh:mm:ss=hour:minute:second, 24hour
format, DD/MM/YYYY=day/month/year
I.E.: SRT,14:08:30,27/08/2015#000000
Command(no password): SRT,hh:mm:ss,DD/MM/YYYY
To set working time. authorized driving message will
be sent one time when car start at working time; illegal
driving alert will be sent each time the car starts at non
working time, support setting 3 working times
, ******=000000 .n=1-3,h1:m1=start time,h2:m2=end time
please set
I.E. SWT1,08:09,10:30
Command(no password): SWTn,h1:m1,h2:m2
To get balance of SIM card in the tracker
******=000000, T=SIM service center No.，China: 10086
x=code to get balance.China:101. I.E.: BAL;10086;101
Command(no password) BAL;T;x
To update device firmware by air, during updating
do not accept any operation, update duration is 3-4mins
when it is done, you will get a message
******=000000. I.E.: AUP#000000
Command( no password) AUP
Switch to LBS tracking, it still can track with GPS
******=000000 .x=0，close(default),x=1,active
I.E.: LBS1#000000
Command(no password): LBSx
Trackers do not get shake or any operation during
the preset time, enter ppwer saving mode. close
GPS,GPRS, you can recovery it by commands
******=000000. x=0，close(default),x=1-99mins
Command(no password)SPSx
To set engine status (on/off) report. ******=000000
1st x=send SMS or not when engine is on.
2nd x=send SMS or not when engine is off.
x=0, close(default), x=1, active
I.E： SOO1000#000000 Engine on, send SMS only
Command(no password): SOOxx00
Command List
9