Remote Control Display; Features; Unpacking The Appliance - Rinnai RHFE-950ETR Operation & Installation Manual

ABOUT THE RHFE-950ETR / RHFE-1250ETR SPACE HEATER

REMOTE CONTROL DISPLAY

23
MAIN DISPLAY
Displays current Clock, Timer or
Temperature status.
24
MAIN DISPLAY MODE
Indicates that controller is in Time
or Temperature display modes.
25
CLOCK SET INDICATOR
Displays when the Clock Set mode
is selected.
26
TIMER 1 INDICATOR
Displays to indicate current status
of Timer 1.
27
TIMER 2 INDICATOR
Displays to indicate current status
of Timer 2.
28
LOCK INDICATOR
Displays when the Lock mode is
activated.

FEATURES

• Room Sealed: Air for combustion is taken from the outside and the flue products are exhausted to the outside.
This means heater operation has no effect on the composition and quality of air in the room.
• Push Button Ignition: Only one touch of the STANDBY/ON switch is all that is required to operate the heater.
• Lock: When the Lock function is activated all controls other than the STANDBY/ON switch will be locked.
Deactivating the lock releases the controls. If the lock is activated when the appliance is in STANDBY, all
functions will be locked.
• Memory: The heaters micro-computer records preset temperatures, timer programming, and operational
modes. Even in the event of a power failure, the need for reprogramming is minimised.
• Dual Timer: The Dual Timer allows you to program the appliance to operate for two separate periods each
day. Once programmed the heater can then be controlled by selection of the Timer 1 and or Timer 2
functions.
The Dual Timer feature means that you can "Set and Forget" your heater. It will turn itself ON or to STANDBY
at the times you have programmed until you cancel the Timer program.
• Pre-Heat: This function automatically operates the appliance before the programmed ON time of the Timer,
in order to heat a room to the pre-set temperature by the programmed ON time.
• Remote Control: Full function cordless remote for the convenience of operating the heater from a distance.
• Extra Low Function: The Extra low function is an energy saving feature designed to control the room
temperature economically. If the room temperature continues to rise above the set temperature on thermostat
the main burner will turn down to its lowest setting. When the room temperature requires further heating the
heater will automatically re-ignite to warm the room.

UNPACKING THE APPLIANCE:

Check for damage and missing parts. If the heater is damaged or missing any parts, contact your supplier for
advice. Before installing the appliance, check it is labelled for the correct gas type (see label on top rear of heater).
Refer to local gas authority for confirmation of gas type if you are in doubt.
Rinnai Australia
29
28
23
24
25
26
27
7
31 29
30
30
31
32
32
OVERRIDE INDICATOR
Displays when Override has been
selected.
EXTRA LOW INDICATOR
Displays when Extra Low function
has been selected.
FLAME INDICATOR
Displays current flame picture setting
when Flame mode is activated.
TRANSMISSION SIGNAL
Displays when data is transmitted.
Operation Manual