Connect To The Vehicle Battery - Intermec 6820 Installation Instructions Manual

6820 Printer Installation Instructions

Connect to the Vehicle Battery

Your vehicle has either a top-mount battery with the terminals on the top;
or a side-mount battery with terminals on the side. Determine which bat-
tery is in your vehicle and proceed with applicable instructions:
Connect to a Side-Mount Vehicle Battery
Do the following to attach the vehicle battery cable to a side-mount battery
terminal as shown in the following illustration:
1 First, disconnect the negative battery cable, then disconnect the positive
battery cable, and remove the bolts from each cable.
2 Screw a 3/8" nut as far as it will go onto a 3/8" x 1-1/2" bolt furnished in
kit, then slip a 3/8" washer onto the bolt.
3 Slide the positive (red wire with fuse link) terminal ring from the printer
power cable onto the bolt.
4 Slip a second 3/8" washer, then slip the vehicle positive battery cable onto
the bolt.
5 Thread bolt assembly (steps 2-4) into the positive (+) battery terminal.
6 Securely tighten the bolt, then the nut installed in step 2 to secure wash-
ers and cables into place.
7 Repeat steps 2-6 for the negative vehicle battery cable wire (black or
brown), hooking up the negative cable to the negative battery terminal.
3/8" nut
3/8 x 1-1/2" bolt
3/8" washers
Vehicle battery
Vehicle battery cable
Fuse holder
5