Secure The Vehicle Battery Cable - Intermec 6820 Installation Instructions Manual

6
Connect to a Top-Mount Vehicle Battery
Do the following to attach the vehicle battery cable to a top-mount battery
terminal as shown in the following illustration:
1 First, disconnect the negative battery cable, then disconnect the positive
battery cable.
2 Remove the bolts from the battery cable and replace these bolts with
3/8" x 1-1/2" bolts and nuts furnished in the installation kit.
3 Reinstall the positive battery cable, then tighten the nut securely.
4 Slip a 3/8" washer onto the extended end of each bolt.
5 Slide the positive (fuse link with red wire) terminal ring from the printer
power cable onto the positive (+) battery bolt.
6 Slip a second 3/8" washer onto the bolt, then thread and tighten a sec-
ond 3/8" nut onto that bolt.
7 Repeat steps 5 and 6 for the negative battery cable wire (black or brown),
connecting the wire to the negative battery terminal.
3/8" nut
Washers

Secure the Vehicle Battery Cable

1 Secure the vehicle battery cable every 18" (50 cm) with adjustable cable
clamps. Work from the battery to the mounting area for the printer.
2 Remove the paper backing from a clamp (P/N: 807-059-001) and stick
the clamp in place while drilling a pilot hole with a #26 drill bit. Use #6
sheet-metal screws to permanently hold clamps in place.
#6 sheet-metal screw goes here
3/8" x 1 1/2" bolt
Vehicle battery
Vehicle battery cable
Fuse holder
6820 Printer Installation Instructions