Prepare The Vehicle Battery Cable - Intermec 6820 Installation Instructions Manual

4

Prepare the Vehicle Battery Cable

After you route the vehicle battery cable to the vehicle battery, do the fol-
lowing to prepare the vehicle battery cable for the terminal ring and fuse
link assembly.
Strip the Vehicle Battery Cable Jacket
Strip the gray vehicle battery cable jacket and insulation:
1 Cut the gray battery cable near the battery to avoid coiling or tying
excess cable.
2 Strip the battery cable jacket (gray) back 12-14" (31-36 cm).
3 Strip 1/4" (6 mm) of insulation from the black (or brown) and red wires.
Gray battery cable
P/N: 226-271-101
Crimp the Cable Ends
Do the following to attach a terminal ring and a preassembled in-line fuse
link to the vehicle battery cable.
Note: You may have to shorten and restrip the red wire when attaching the
fuse link assembly.
1 Strip the black wire.
2 Crimp the 3/8" terminal ring (P/N: 809-165-001) onto the black wire.
3 Attach the fuse link assembly (P/N: 315-071-002) to the red wire (if
needed, shorten red wire), strip 1/4" (6 mm) of insulation off the red wire.
4 Crimp the red wire onto the fuse link.
3/8" terminal ring
Black (or brown) wire
Vehicle battery cable
Red wire
Red wire
Black (or brown) wire
Strip the cable jacket 12" to 14" (31-36 cm)
Strip the wire, then install the terminal ring
Fuse link
Crimp here
Fuse link assembly
P/N: 236-107-001
6820 Printer Installation Instructions
Strip each wire end
1/4" (6 mm)