Emc Shielding Clamps; Tools - Barco NH-12 Service Manual

• before removing a wire, carefully take notice of its position
• when pulling a wire through a slot of the chassis, makes sure the connector does not get stuck
• when reinstalling a wired component, make sure the wire is in its original position
Cable ties
Different types of cable ties are used in this projector. Some of them can be reused, others need to be cut and will have to be
replaced by new ones during service activities.
Image 3-2
Cable tie: single use
Put the new cable ties in the same position as it has been done in production.
C
AUTION
3.3.3

EMC shielding clamps

EMC shielding clamps
When replacing wires or components, always put back the EMC shielding clamps in their original position.
Image 3-6
EMC shielding clamp
Depending on the type of EMC shielding clamp, use a pair of cutting pliers and/or a slotted screwdriver to open the clamp.
3.4

Tools

Overview of the tools needed for servicing procedures
This is a list of all the tools that may be needed when servicing the projector in the field.
Description
Torx screwdriver T7
Torx screwdriver T10
Torx screwdriver T20
Phillips screwdriver Ph1
Phillips screwdriver Ph2
Hex or Allen™ key 2.5 mm
nut spanner 4.5 mm or 3/16"
R59770158 NH-12 20/02/2008
Image 3-3
Cable tie: reusable
:
When cutting a cable tie, make sure not to damage the wires!
Image 3-7
EMC shielding clamp
Image 3-4
Cable tie mounting: reusable
Mostly used for
electronic parts
electronic parts
mechanical parts
small covers
mechanical parts
mechanical parts
DVI connectors
3. General information
Image 3-5
Cable tie mounting: reusable
13