ZyXEL Communications P-660HW-Tx v3 Support Notes page 73

(Set the protocol ID as 6(TCP) for the rule)
ip policyrouting set criteria serviceType
(Set the criteria type of service as don‟t care for this rule)
ip policyrouting set criteria precedence
(Set the precedence as don‟t care for this rule)
ip policyrouting set criteria packetlength
(Set the packet length as 0 for the rule)
ip policyrouting set criteria srcip
(Set the source IP address for the rule: Start=192.168.1.2, end=192.168.1.20)
ip policyrouting set criteria srcport
(Set the source port for the rule: Start=0)
ip policyrouting set criteria destip
(Set the destination port for the rule: Start=0.0.0.0)
ip policyrouting set criteria destport
(Set the destination port for the rule: Start=80, end=80)
ip policyrouting set action
(Set the action for the rule: Matched)
ip policyrouting set action gatewaytype
(Set gateway type for the rule: Gateway Address)
ip policyrouting set action gatewayaddr
(Set the gateway address for the rule: 192.168.1.254)
ip policyrouting set criteria serviceType
(Set the action type of service as don‟t care for this rule)
ip policyrouting set criteria precedence
(Set the action precedence as don‟t care for this rule)
ip policyrouting set action log
(Set log option for the rule: no log)
ip polictrouting set save
(Save the rule)
Step 3: Apply the IP policy routing. There are two interfaces to apply the policy
set, they are the LAN interface and WAN interface. It depends where the
gateway specified in the policy rule is located. If the gateway you specified is
located on the local LAN you apply the policy set in LAN interface. If the
gateway you specified is located on the remote WAN site you apply the policy
set in WAN interface.
Apply to WAN Interface (Suppose we apply it to remote node
example):
wan node index 1
wan node ippolicy
All contents copyright © 2008 ZyXEL Communications Corporation.
192.168.1.2 192.168.1.20
0
0.0.0.0
actmatched
no
1
P-660HW-Tx v3 Series Support Notes
0
8
0
80 80
0
192.168.1.254
0
8
1 in the
73