ZyXEL Communications P-660HW-Tx v3 Support Notes page 49

Example
The following example shows how to dial to an ISP via the P-660HW-Tx v3
and then establish a tunnel to a private network. There will be three items that
you need to set up for PPTP application, these are PPTP server (WinNT),
PPTP client (Win9x) and the P-660HW-Tx v3.
(1) PPTP server setup (WinNT)

Add the VPN service from Control Panel ->Network

Add an user account for PPTP logged on user

Enable RAS port

Select the network protocols from RAS such as IPX, TCP/IP NetBEUI

Set the Internet gateway to P-660HW-Tx v3
(2) PPTP client setup (Win9x)

Add one VPN connection from Dial-Up Networking by entering the
correct username & password and the IP address of the P-660HW-Tx
v3's Internet IP address for logging to NT RAS server.

Set the Internet gateway to the router that is connecting to ISP
(3) P-660HW-Tx v3 setup

Before making a VPN connection from Win9x to WinNT server, you
need to connect P-660HW-Tx v3 router to your ISP first.

Enter the IP address of the PPTP server (WinNT server) and the
port number for PPTP as shown below:
All contents copyright © 2008 ZyXEL Communications Corporation.
P-660HW-Tx v3 Series Support Notes
49