Frigidaire FRS123LS1 Use & Care Manual page 13

louver is 6
the louver swings at a certain angle
which would affect the cooling and
heating effect of the air conditioner,
it would automatically change the
swing direction . No symbol will
appear in the display area when
pressing this button. (Not applicable
to units without this function).
LED (screen): Press this button to
7
erase the digits that are shown in
the screen of the air conditioner.
Press again to activate.
TEMP
8
increase the indoor temperature
setting.
FAN SPEED: This button is used
9
for setting Fan Speed in the
sequence that goes from AUTO,
LOW, MED to HIGH, then back to
Auto.
AUTO
ON/OFF: Press this button to start
10
the unit operation. Push the button
again to stop the unit operation.
TIMER ON: Press this button to
11
initiate the auto-on timer. Each
press will increase the auto-
timer setting in 30 minutes
increments. When the setting time
displays 10:00, each press will
increase the auto-timer setting in 60
minutes increments. To cancel the
auto-timer program, simply adjust
the auto-on time to 0:00.
Remote control description
35
o
for each press. When
: Press the button to
LOW MED
TIMER OFF: Press this button to
12
initiate the auto-off timer. Each
press will increase the auto-timer
setting in 30 minutes increments.
When the setting time displays
10:00, each press will increase
the auto-timer setting in 60
minutes increments. To cancel the
auto-timer program, simply adjust
the auto-off time to 0:00.
LOCK: When you press the
13
recessed LOCK button, all current
settings are locked in and the
remote controller does not accept
any operation except that of the
LOCK. Press again to cancel the
LOCK mode.
TURBO*: Press this button to
14
activate/cancel the Turbo function
which enables the unit to reach the
preset temperature in the shortest
time. In cooling mode, the unit
HIGH
will blow strong cooling air with
super high fan speed. In heating
mode (only applicable to the
models with heating function,
which adopts PTC), the PTC will
bring fast heating operation.
*Only for some models