Table of Contents
Advertisement
NOTE
When you connect a printer, be sure to install
the appropriate printer driver through the Windows
Control Panel.
Follow these steps to connect a serial device to your NEC
Versa.
Check that both the NEC Versa and the device power
1.
are off.
Open the port cover on the back of the system and locate
2.
the serial port.
Align and connect the 9-pin connector with the serial
3.
port on the system. Secure the connection with the
screws provided.
Align and connect the other end of the cable to the ap-
4.
propriate port on the device. Secure the connections with
the screws provided.
Connect the power cable to the device and a properly
5.
grounded wall outlet.
Connecting a serial device
Using Your NEC Versa 4-33
Advertisement
Table of Contents
