Table of Contents
Advertisement
T
16-MB memory module.
NOTE
when installing two modules. Modules with different
capacities that are installed together do not work
properly.
Install DIMMs as follows.
Make sure the system is powered off and that no periph-
1.
eral devices are attached.
Open the LCD panel.
2.
3.
Locate the two speaker caps. Slide each one away from
the system and pop it off the unit.
4.
Gently lift the edge of the keyboard nearest the LCD up,
turn it upside down, and rest it on the VersaGlide. Be
careful not to twist the keyboard cable.
Be careful not to remove the keyboard or keyboard
cable entirely from the system.
Locate the LED guard and pry it up and off of the
5.
system.
Locate the DIMM sockets. The top socket is connector 0
6.
and should be used when installing only one module.
The bottom socket sits a little in front of the top socket
for easier access. However, installation for both sockets
is the same.
4-26 Using Your NEC Versa
Always use modules of the same capacity
!
CAUTION
Advertisement
Table of Contents
