Grandstream Networks GXP – 2000 User Manual page 17

Display "Configure"
Display "Factory Functions"
Display "Reboot"
Display "Ring Volume"
Display "Ethernet Loopback"
Display "Audio Loopback"
Display "Diagnostic Mode"
Display "Factory Reset".
Grandstream Networks, Inc.
Press Menu button to display the configuration selections:
"Network" or
"SIP" or
"Audio" or
"Upgrade" or
"Factory Reset"
More detailed information on these selections are in the web
configuration page.
Press '↓' or '↑' to toggle the selection.
Press '←' to return the main menu.
Press Menu to display th
"Ethernet Loopback" or
"Audio Loopback" or
"Diagnostic Mode" or
"Enable Diag Port" or
"Back"
Press '↓' or '↑' to toggle between selections.
Press '←' to return to the main menu.
Press Menu button to reboot the device
Display "Exit"
Press Menu button to exit the menu
Press Menu button to hear the selected ring v
h ear and adjust the ring tone volume.
Press Menu button to select and exit, take effect immediately.
Press Menu button to enter this mode
Connect a cross Ethernet cable from your "PC" port, and the "LAN" port.
The test result is displayed on the screen. Use this feature to diagn
the state of health of the RJ45 jacks.
Press Menu button to exit the diagnostic mode.
Note: Running the Ethernet Loopback mode with a norm
will cause IP loss.
Press Menu button to enter this mode
Speak into the handset. If you h
w orks fine.
Press Menu button to exit the mode.
Press Menu button to enter t
Press any key on the keypad, to display the button name in the LCD. Lift
and put back the handset or press
mode.
Key in the physical/MAC address on back of the phone.
Press Menu button to reset FACTORY DEFAULT setting. Do not use
Factory Reset unless you want to restore factory settin
GXP-2000 Users Manual
Firmware 1.1.1.14
e factory function items including
olume, press '←' or ' →' to
ear your voice in the handset, your audio
his mode, all LEDs will light up
Menu button to exit the diagnostic
ose
al connection
gs
Page 17 of 33
Last Updated: 12/2006