Table of Contents
Advertisement
Operation
This is where the action the rule will take is defined. Select one of the following
radio buttons:
• Drop - Deny access to packets that match the source and destination
addresses and protocol ports defined in "Matching."
• Reject - Deny access to packets that match the source and destination
addresses and protocol ports defined in upper section of the screen, and
send an
ICMP
• Accept - Allow access to packets that match the source and destination
addresses and protocol ports defined in upper section of the screen. The
data transfer session will be handled using Stateful Packet Inspection (
• Accept Packet - Allow access to packets that match the source and des-
tination
IP
screen. The data transfer session will not be handled using Stateful Packet
Inspection (
cally allowed access. This setting is useful when creating rules that allow
broadcasting.
Logging
Click in this check box to add entries relating to this rule to the security log.
Scheduler (When should this rule occur?)
If advanced filtering needs to be active all the time, select "Always" from the "When
should this rule occur?" drop-down list. If the rule will only be active at certain times
select Specify Schedule and click Add. Then, add a schedule rule (for more details
about schedule rules, see the "Advanced Settings" chapter of this manual)
Actiontec Broadband Router User Manual
error or a
TCP
addresses and protocol ports defined in upper section of the
), so other packets that match this rule will not be automati-
SPI
reset to the origination peer.
64
IP
IP
IP
).
SPI
Advertisement
Table of Contents
