Section 8: Installing & Removing The Door - Montigo L42DFN Installation & Maintenance Manual

Section 8: Installing & Removing the Door
Removing the door:
The L42DF* door is removed in a few simple steps. Follow these
instructions below to remove the Horizontal access panel, unlatch the
door buckles and, remove the door. Replace in reverse order.
WARNING
When reinstalling door(s), always make sure all door
buckles are properly hoooked and fully engaged.
Step 1:
Remove the Horizontal cover
by placing fingers in both finger
holes, then pushing away from
you and lifting out. Place it aside
during maintenance or cleaning.
Install in reverse order.
Figure 26. Removing and installing the Horizontal Access Panel
Step 2: Locate the Door Buckles.
Figure 26a. Door buckle locations.
Step 3:
Locate Door Buckle Tool.
Hand-hold
Figure 26b. Door buckle Tool
XG0181 - 150204
Installation
Finger Holes
Installed Gas
Valve Cove r
Door Latch Slot
Door Latch Hook
Step 4:
Firmly grasp hand-hold
end of Door buckle tool
and place the machined
end in the slot under door
frame. (as shown)
Figure 26c.
Step 5:
Ensure the tool is firmly in
the lower end of the slot,
(as shown), Then pull toward
you (Caution: hold the tool
securely).
Figure 26d.
Step 6:
Pull hard if necessary to
release the spring tension.
(Caution: The latch springs
back with force, hold the tool
securely).
Figure 26e.
Step 7:
Remove the tool from the
latch slot. Ensure the latches
are hanging freely, the hook
end is released from the
bottom of the door. (Repeat
all 4-steps for the remaining
latches).
Figure 26f.
L42DF* Indoor Gas Fireplace
2
3
4
Page 25