Table of Contents
Advertisement
The procedures below may vary depending on version of Linux and X-windows shell.
a) Start X-Windows.
b) Select Control Panel
c) Select the "Interface" entry for your Network card. Normally, this is called "eth0".
d) Click "Edit" button, set the "protocol" to "DHCP" and save.
e) To apply all changes, use Deactivate and Activate buttons, if it is possible, restart
your system.
2.3 Configure Wireless Stations
This section describes how to configure all the wireless stations use Wireless Router as
an Access Point. Each wireless station must have compatible settings as below.
Mode
All wireless stations must be set to "Infrastructure" mode.
SSID
This code must match the value uses for the Wireless Router. (Note: SSID
(ESSID)
code is case sensitive.)
WEP
By default, WEP encryption is set to 64-bits 10 hex digit.
WPA
By default, WPA-PSK Pass Phrase is set at PassPhrase, WPA G-Rekey
Interval is set at 0 and WPA Data Encryption is at TKIP.
3. Setup Wireless Router Configurations via Web Browser
The Wireless Router comes with a web-based configuration utility. Users can access
this configuration utility from any of client system within Wireless Router's LAN. For best
results, either use Microsoft Internet Explorer 5.0 or later, or Netscape Navigator 4.7 or later.
Before you start configuring your Wireless Router, you have to get following information
from your ISP:
a) Has your ISP assigned you a static IP address, or they will assign one to you
dynamically? If you have received static IP address, what is it?
b) Does your ISP use PPPoE? If so, what is your PPPoE username and password?
If you are not sure of above questions, please contact your ISP.
3.1 Start your Web Browser
To use the Web-Based Utility, you have to launch your Internet Browser (MS IE 5.0 or
later, Netscape Navigator 4.7 or later).
Step1:
Enter Wireless Router default IP address
field then press Enter,
Network.
http://192.168.10.1
19
in the Address
Advertisement
Table of Contents
