Charging T He Bat T Ery - Datamax APEX 2 User Manual

1 .2 .2 Ch a r gin g t h e Ba t t e r y

Plug t he bat t ery charger adapt er out put cable int o t he bat t ery charger connect or as

shown.
Plug t he bat t ery charger adapt er int o

t he appropriat e AC line volt age socket .
The Yellow / Am ber charging LED will
illum inat e indicat ing t hat t he bat t ery is

charging.
The bat t ery will be fast charged and
aft er about 180 m inut es t he LED will

t urn off.
To rem ove t he bat t ery cart ridge, open
t he bat t ery door and t ip t he bat t ery out
of t he print er.
Note: To ensure a full charge do not operate the printer while charging.
Note: The wall mounted charger is Class II equipment (
with most international standards. The wall mounted charger is not supplied with plugs for use in
Korea.

The wall m ount ed charger has t he follow ing specificat ions:
M ode l
I n pu t Volt a ge / Cur r e n t
I n pu t Fr e qu e n cy
Ou t pu t V olt a ge / Cur r e n t (
Do not use a charger not approved by Datamax-O'Neil for use with the APEX 2 series.
Use of an unapproved charger could damage the battery pack or the printer and will
void the warranty.
The battery terminals are well recessed inside the printer. Do not allow them to contact
conductive material since this may create a short circuit, which could cause injury or
start a fire.
When using the wall mounted charger ensure the socket outlet is close to the printer
and easily accessible during the battery recharging process. Switch the socket off (if
supplied with a socket switch), pull out the charger from the socket, or disconnect the
plug from the printer in case of any problems.
FI GURE 3 : CH ARGI N G TH E BATTERY
). Multiple plug configurations comply
APEX 2
100- 240 VAC/ 0.55A
50- 60 Hz
) 10VDC/ 2.4A
4