3.
Remove the three 6 mm flange bolts, and remove the exhaust tail
pipe and the spark arrester.
EXHAUST TAIL PIPE
6 mm FLANGE BOLT
4.
Use a brush to remove carbon deposits from the spark arrester
screen.
Be careful to avoid damaging the screen.
The spark arrester must be free of breaks and tears. Replace the
spark arrester if it is damaged.
5.
Install the spark arrester and the exhaust tail pipe in the reverse
.
order of removal.
TORQUE:
8 lbf·ft (11 N·m , 1.1 kgf·m)
6.
Install the muffler protector and the rear pipe in the reverse order of
removal.
TORQUE:
6.3 lbf·ft (8.5 N·m , 0.87 kgf·m)
SERVICING YOUR GENERATOR
6 mm FLANGE BOLTS
SPARK ARRESTER
55