Sharp AL-2060 Operation Manual page 76

TROUBLESHOOTING AND MAINTENANCE
Problem
Paper size for a paper
tray cannot be set.
Output does not stack
neatly in the paper
output tray.
A copy job stops before
it is finished.
The power save
indicator is lit.
Error indicator (
lit or blinking.
Lighting fixture flickers.
74
Cause and solution
Copying or printing is performed.
→ Set the paper size after copying or
printing is complete.
The machine has stopped temporarily
due to running out of paper or a
misfeed.
→ Load paper or remove the misfeed, and
then set the paper size.
Both ends of the paper are curled
upward.
→ Turning the paper over in the paper tray
may help.
"MEMORY FULL, PRESS START TO
RESUME." appears in the display.
→ The memory became full during sort
copy. Copy only the originals that have
been scanned to that point, or cancel
the job and clear the data from memory.
The tray is out of paper.
→ Load paper.
Other indicators are lit.
→ If other indicators are lit, the machine is
in preheat mode. Press any key on the
operation panel to resume normal
operation.
Only the power save indicator is lit.
→ If only the power save indicator is lit, the
machine is in auto power shut-off
mode. Press the [START] key (
resume normal operation.
See "DISPLAY MESSAGES" to check the
) is
meaning of the error indicator and error
message in the display, and take
appropriate action.
The same power outlet is used for the
lighting fixture and the machine.
→ Connect the machine to a power outlet
which is not used for other electric
appliances.
Page
-
19, 23,
78
20
34
20
17
17
) to
69
-