Enhancing Your System - Sharp XL-UR14H Operation Manual

Timer and sleep operation (Remote
control only) (continued)
To confirm the remaining sleep time:
1
Whilst "SLEEP" is indicated, press the SLEEP button.
The remaining time is displayed for about 10 seconds.
To cancel the sleep operation:
Press the ON/STAND-BY button whilst "SLEEP" is
indicated. To cancel the sleep operation without setting the
unit to the stand-by mode, proceed as follows.
1
Whilst "SLEEP" is indicated, press the SLEEP button.
2
Within 10 seconds, press the SLEEP button repeatedly
until "SLEEP" indicator disappears.
■
To use timer and sleep operation together
Sleep and timer playback:
For example, you can fall asleep listening to the radio and
wake up to CD in the next morning.
1
Set the sleep time (see above, steps 1 - 5).
2
Whilst the sleep timer is set, set the timer playback
(steps 2 - 10, page 16).
Timer playback setting
Sleep timer setting
10 - 90 minutes
Sleep operation will
automatically stop
2012/ October/ 17 12_XL-UR14H_OM_EN.fm

Enhancing your system

The connection lead is not included. Purchase a
commercially available lead as shown below.
■
Listening to the playback sounds of
portable audio player, etc.
End time
1
Use a connection lead to connect the portable audio
Desired time
player etc. to the AUDIO IN socket.
Timer playback
2
Press the ON/STAND-BY button to turn the power on.
start time
3
Press the FUNCTION button repeatedly to select
AUDIO IN function.
4
Play the connected equipment. If volume level of the
connected device is too high, sound distortion may
occur. Should this happen, lower the volume of the
connected device. If volume level is too low, increase the
volume of the connected device.
Note:
To prevent noise interference, place the unit away from the
television.
■
Headphones
●
Do not turn the volume on to full at switch on and listen
to music at moderate levels. Excessive sound pressure
from earphones and headphones can cause hearing
loss.
●
Before plugging in or unplugging the headphones,
reduce the volume.
●
Be sure your headphones have a 3.5 mm (1/8")
diameter plug and impedance between 16 and 50
ohms. The recommended impedance is 32 ohms.
●
Plugging in the headphones disconnects the speakers
automatically. Adjust the volume using the VOLUME
control.
E-17
Portable
audio
player, etc.
Audio cable
(not supplied)
XL-UR14