Using The Radio Data System (Rds) - Sharp XL-UR14H Operation Manual

Listening to the Radio (continued)
■
Memorising a station
You can store 40 FM stations in memory and recall them
at the push of a button. (Preset tuning)
1
Perform steps 2 - 3 in "Tuning".
2
Press the MEMORY button.
3
Within 5 seconds, press the PRESET (
to select the preset channel number. Store the stations
in memory, in order, starting with preset channel 1.
4
Press the MEMORY button to store that station in
memory. If the "MEMORY" and preset number
indicators disappear before the station is memorised,
repeat the operation from step 2.
5
Repeat steps 1 - 4 to set other stations, or to change a
preset station. When a new station is stored in the
memory, the station previously memorised for that
preset channel number will be erased.
Note:
The backup function protects the memorised stations for a
few hours should there be a power failure or the AC power
lead become disconnected.
■
To recall a memorised station
Press the PRESET ( or
seconds to select the desired station.
■
To scan the preset stations
The stations saved in the memory can be scanned
automatically. (Preset memory scan)
1
Press the PRESET (
seconds. The preset number will flash and the
programmed stations will be tuned in sequentially, for 5
seconds each.
2
Press the PRESET (
desired station is located.
■
To erase entire preset memory
1
Press and hold down the (CLEAR)/DISP button until
"TUN CLR" appears.
2012/ October/ 17 12_XL-UR14H_OM_EN.fm
or ) button
) button for less than 0.5
or ) button for more than 0.5
or ) button again when the
E-13

Using the Radio Data System (RDS)

RDS is a broadcasting service which a growing
number of FM stations provide. These FM stations
send additional signals along with their regular
programme signals. They send their station names,
and information about the type of programme such as
sport, music, etc.
When tuned to an RDS station, "RDS" and the station
name will be displayed.
"PTYI" (Dynamic PTY Indicator) will appear whilst the
Dynamic PTY station is received.
You can control the RDS by using the buttons on the
remote control only.
■
Information provided by RDS
Each time the RDS DISPLAY button is pressed, the
display will switch as follows:
Station name (PS)
Programme type (PTY)
Frequency
When tuning in to a station other than an RDS station or
to an RDS station which sends weak signal, the display
will change in the following order:
NO PS
FM 98.80 MHz
■
Using the Auto Station Programme
Memory (ASPM)
Whilst in the ASPM operation mode, the tuner will
automatically search for new RDS stations. Up to 40
stations can be stored.
If you have already stored some stations in memory, the
number of new stations you can store will be less.
1
Press the FUNCTION button repeatedly to select
TUNER function.
2
Press and hold down the RDS (ASPM) button on the
remote control for at least 3 seconds.
1 After "ASPM" has flashed for about 4 seconds,
scanning will start (87.50 - 108.00 MHz).
Radio text (RT)
NO PTY
NO RT