Something Not Working - AEG FAVORIT 65080 VIL Instruction Book

152953 43/0en 30-08-2005
Operating instructions

Something not working

Certain problems are due to the lack of simple maintenance or
oversights, which can be solved with the help of the instructions given
here, without calling out an engineer.
...there are problems when operating the dishwasher
The dishwasher will not start or stops during operation and a sequence
of intermittent audible signals are heard.
The point-shaped optical signal on the floor beneath the dishwasher's
door is flashing (not visible if the appliance has been installed higher
up with a furniture door mounted flush).
Open the dishwasher's door.
The intervention of an alarm is indicated by:
- the continuous flashing of the indicator light of the running
programme,
- a fault code (as described in the chart) is visible in the digital display.
Carry out the following suggested corrective actions.
Fault code / Malfunction
appears in the
digital display
The machine does not fill
with water
appears in the
digital display
The dishwasher will not
drain
appears in the
digital display
36
9:47 Pagina 36
Possible cause
The water tap is blocked or
furred with limescale.
The water tap is turned off.
The filter (where present) in
the threaded hose fitting at
the water inlet valve is
blocked.
The water inlet hose has not
been correctly laid or it is
bent or squashed.
The sink spigot is blocked.
The water drain hose has not
been correctly laid or it is
bent or squashed.
Anti-flood device is activated.
Solutions
Clean the water tap.
Turn the water tap on.
Clean the filter in the
threaded hose fitting.
Check the water inlet hose
connection.
Clean out the sink spigot.
Check the water drain
hose connection.
Close the water tap and
contact your local Service
Force Centre.