Something Not Working - AEG FAVORIT 50863 Instruction Book

117998 91/0 21-04-2006

Something not working

Certain problems are due to the lack of simple maintenance or
oversights, which can be solved with the help of the instructions given
here, without calling out an engineer.
...a flashing fault code appears
The dishwasher will not start or stops during operation.
The intervention of an alarm is indicated by:
- the continuous flashing of the indicator light of the running
programme,
- a fault code (as described in the chart) is visible in the digital display.
Open the door and carry out the following suggested corrective
actions.
Fault code / Malfunction
- appears in the
digital display
The machine does not fill
with water
- appears in the
digital display
The dishwasher will not
drain
- appears in the
digital display
Once the checks have been carried out, close the door and press the
button of the programme that was running before the intervention of
the alarm, the programme will continue from the point at which it was
interrupted. If the fault code reappears contact your local Service
Force Centre.
For other combinations of fault codes not described in the above chart
will appear, please contact your Service Force Centre.
14:46 Pagina 35
Possible cause
The water tap is blocked or
furred with limescale.
The water tap is turned off.
The filter (where present) in
the threaded hose fitting at
the water inlet valve is
blocked.
The water inlet hose has not
been correctly laid or it is
bent or squashed.
The sink spigot is blocked.
The water drain hose has not
been correctly laid or it is
bent or squashed.
Anti-flood device is activated.
Operating instructions
Solutions
Clean the water tap.
Turn the water tap on.
Clean the filter in the
threaded hose fitting.
Check the water inlet hose
connection.
Clean out the sink spigot.
Check the water drain
hose connection.
Close the water tap and
contact the Service Force
Centre.
35