Electrical Connection - AEG FAVORIT 65080 VIL Instruction Book

152953 43/0en 30-08-2005

Electrical connection

Information concerning the electrical connection is given on the
rating plate on the edge of the dishwasher's door.
Before plugging the appliance into the wall socket, make sure that:
1. The mains voltage and current rating at the site of installation
match the nominal voltage and current rating given on the rating
plate.
2. The meter, fuses, mains power supply and wall socket can all take
the maximum load required. Make sure that the socket and plug
are compatible without having to use any type of adaptor.
If necessary, have the domestic wiring system socket replaced.
To isolate the dishwasher from mains, remove the mains plug.
Important!
The plug must still be accessible after the appliance has been
installed.
In case that the electrical cable has to be replaced, please contact
your local Service Force Centre.
The appliance should not be connected to the electrical supply by
means of an extension cable.
Safety standards require the appliance to be earthed.
The manufacture accepts no liability for failure to observe the
above safety precautions.
9:47 Pagina 45
Installation instructions
45