Table of Contents
Advertisement
The receiver will display a list with 8 timers, followed by their respective status. Select the timer
you wish to set or change with
The timer setup menu will now be displayed.
The following settings are available:
Timer Mode:
Choose between Off (Timer inactive), Once, Daily (Timer will be executed
every day, same time) or Weekly (Timer will be executed every week, same
day, same time) and Monthly (Timer will be executed every month, same day,
same time).
Timer Service:
Choose between Channel (Timer will wake up the receiver) or Record (Timer
will start to record the scheduled event).
Wakeup Channel:
Use
Wakeup Date:
Use the 0~9 buttons to input the date for the timed event.
Wakeup Time:
Use the 0~9 buttons to input the start time.
Duration:
Use the 0~9 buttons to input the timer duration.
When all settings are according to your wishes, use
ok to confirm. To quit the timer without saving your settings, move the highlight to Cancel.
7.3.5 parental lock
This menu allows you to protect the installation menu and/or channels with a PIN code. You can
also enter a new PIN code in the Parental Lock menu.
pq
Use
to select Parental Lock from the System Setup menu and press ok to proceed. You will
be asked to enter your PIN code. (defaulT pIn: 1234)
Menu Lock:
Locks the installation menu. You can set Menu Lock to On or Off.
Parental Rating:
Choose between: Off, 4 years and up to 18 years. Channels with a parental
rating above the chosen age will be protected with a PIN code (if available in
your local broadcast.)
New Password:
Enter your new PIN code (4 digits) here.
Confirm Password:
Re-enter your PIN code here to confirm.
7.3.6 oSd Setting
This menu allows you to change settings for: OSD Timeout and OSD Transparency.
OSD Timeout:
Sets the time after which on screen banners and messages disappear. The
range is 1~10 seconds or Always On.
OSD Transparency:
To set the OSD transparency from Off ~ 40% with 10% steps.
Load Default OSD Setting:
Press ok to clear all OSD settings and reset to default values.
7.3.7 auto Standby
Auto Standby is a new feature that helps you reducing power consumption. When set to 30Min/1
Hour/2 Hours or 3 Hours, the receiver will switch to standby if it doesn't receive any commands
during this time. Set Auto Standby to Off to deactivate the automatic standby function.
p16
maIn menu
pq
and press ok to proceed.
tu
to select the channel the timer will wake up with.
pq
to move the highlight to Save and press
Hide quick links:
Advertisement
Table of Contents
