Attaching The Connector Cover - Epson TM-T88V-DT Technical Reference Manual

Attaching the Connector Cover

To protect the cables, attach the connector cover in the steps below. When the optional customer
display unit is not installed, attach the connector cover with the U-shaped part.
Be sure to hold both sides of the connector cover when attaching it, or the it may
become damaged.
WARNING
When pulling out the cables whose connectors do not lock themselves (USB cables and
Line-Out cable) from the cable exits on the back, fix the cables with the lock wire saddle to
prevent the cables from coming off.
For the optional powered USB hub unit (OT-PH10), use the connector cover provided with
the hub unit.
1
Pass the interface cables through the locking wire saddle on the pole
mounting plate.
2
Pass each cable through the cable exits at the bottom of the connector
cover.
Chapter 2 Setup
locking wire saddle
2
113