Burner Ignition & Usage; Methods Of Burner Ignition; Burner Ignition Electronic Ignition System; To Extinguish Burner - Weber 3200 Owner's Manual

METHODS OF BURNER
IGNITION
There are two ways to ignite
the burner. The first is by
using the ignition system built
into your grill. The second is
with a match.
Next are the steps for igniting
your grill using the ignition
system. On the following page
are steps for igniting your grill
with a match.
Summary lighting instructions are posted on
the cart leg under the burner control knobs.
Some batteries have a plastic
protective wrap around them.
This plastic must be removed
before you attempt to ignite
your grill. Do not confuse this
plastic with the battery label.
BURNER IGNITION & USAGE
BURNER IGNITION
Electronic Ignition System
The electronic ignition system ignites the burner with a
spark from the igniter electrode inside the Gas Catcher™
ignition chamber. You generate the energy for the spark
by pushing the igniter button. You will hear the igniter
clicking.
A) Open the grill lid (1).
m DANGER
Failure to open the lid before igniting the
grill's burners, or not waiting five minutes
to allow the gas to clear if the grill does
not light, may result in an explosive flare-
up which can cause serious bodily injury
or death.
B) Make sure ALL burner control knobs are turned
off (2). Check by pushing burner control knobs in and
turning them clockwise until they stop.
C) Turn the gas supply valve on (3).
D) Light the outside burner by pushing the large burner
control knob in and turning it counterclockwise to
start/high ( ) position (4).
E) Push and hold in the igniter button (5). You will hear
the igniter clicking.
F) Check that the burner is lit by looking through the
cooking grates. You should see a flame.
m WARNING: While igniting the grill or
cooking, never lean over open grill.
m WARNING: If the burner fails to ignite
within five seconds, stop, turn the burner
control knob to off and wait five minutes
to allow the gas to clear before you try
again or light with a match.
G) After the outside burner is lit, you can turn on the
inside burner. Push in the small burner control knob
and turn it to start/high ( ) position (6). The inside
burner will then be ignited by the outside burner.

TO EXTINGUISH BURNER

Push each burner control knob in and turn it clockwise to
the off ( ) position. Turn gas supply off at the source.
1
3
5
6
WWW.WEBER.COM
2
4
25
®