Zenoah EXZ2610DL Owner's Manual page 27

9. Maintenance
IMPORTANT
• If waste gets stuck and causes blockage around the
intake air cooling vent, it may cause the engine to over-
heat, and that in turn may cause mechanical failure
on the part of the brushcutter.
(1)
(1) Intake air cooling vent (back)
■ PERIODICAL SERVICE POINTS
1. CYLINDER FINS
Periodically check and clean the cylinder fins in the re-
pair specialty store.
9. Maintenance
REFILLING TRIMMING LINE
1. For replacement line, use a diameter of 2.4mm(.095in).
The spool is capable for a line upto 6m(20ft) on the
10cm(4") head. Avoid using a larger line as it may cut
down the trimming performance.
WARNING
• For safety reasons, do not use metalreinforced line.
2. Pinch the slotted area on the both sides of the spool
housing to unhook the bottom cap.
3. Take out the spool and pull off the old line. Put one
end of new line through the spool holes and pull it
until the length is equal between each part of the line.
4. Wind up the line in the correct direction as indicated
on the spool.
5. Hook each end of the line in the slot on the edge of
the spool, and then put the ends through the eyelets
on the housing. Make sure that the spring and the
washers are in place.
6. While holding the spool against the housing, pull the
line ends to release them from the slot.
7. Line up the slot on the bottom cap with the hook on
the housing, press the cap against the housing until it
clicks.
EXZ2610DL
(BC-EX only)
G
B
GB-27