Paper Missing - Lexmark X950 Series User Manual

Troubleshooting
88.xx [color] cartridge low
1
Order a replacement toner cartridge immediately.
2
Remove the specified cartridge.
3
Firmly shake the cartridge side‑to‑side and front‑to‑back several times to redistribute the toner.
4
Reinsert the cartridge, and then touch Continue to clear the message and continue printing.
Note: Repeat this procedure multiple times until the print remains faded, and then replace the cartridge.
88.xx [Color] cartridge very low
The specified print cartridge is very low.
1
For instructions on replacing a print cartridge, from the printer control panel touch More Information.
2
Touch Continue to clear the message and continue printing.
2yy.xx Close flatbed cover and load originals if restarting job
Try one or more of the following:
•
Touch Cancel job to cancel the job and clear the message.
•
Touch Scan from automatic feeder to resume the scan job from the ADF immediately following the last successfully
scanned page.
•
Touch Scan from flatbed to resume the scan job from the scanner glass immediately following the last successfully
scanned page.
• Touch Finish job without further scanning to end the scan job at the last successfully scanned page.
Note: This does not cancel the scan job. All successfully scanned pages will be processed further for copying,
faxing, and e-mailing.

280.06 Paper missing

Try one or more of the following:
• Touch Continue to clear the message.
• Touch Cancel job to cancel the job and clear the message.
•
Touch Scan from automatic feeder to resume the scan job from the ADF immediately following the last successfully
scanned page.
• Touch Scan from flatbed to resume the scan job from the scanner glass immediately following the last successfully
scanned page.
•
Touch Finish job without further scanning to end the scan job at the last successfully scanned page.
Note: This does not cancel the scan job. All successfully scanned pages will be processed further for copying,
faxing, or e‑mailing.
• Touch Restart job to clear the message and start a new scan job with the same settings as the previous job.
291