Disconnecting Cables - Symbol PTC-960XRF User Manual

7. Connect the other end of the adapter cable to
the accessory or to one of the connectors on
the accessory cable. Make sure the connec-
tors line up correctly, wide edge to wide edge,
and you are connecting a male connector to a
female connector.
8. Connect the remaining end of the accessory
cable, if used, to the correct connector on the
computer or accessory. Make sure the connec-
tor on the cable and the connector on the
computer or accessory are lined up properly.
9. Turn on the PTC and then turn on the device
it is connected to.
10. Follow the instructions for your application
program to communicate.

Disconnecting cables

Equipment required:
• A pen or small screwdriver
Always disconnect connectors by pulling them
directly away from each other. Do not pull at an
angle. Do not use a rocking or twisting motion
when pulling two connectors apart.
CAUTION! When removing a cable from the
PTC or another device, grasp the cable con-
nector head to remove the cable. Pulling on
the cable can break the wiring from the cable
connector.
1. Press the ON/OFF key on the PTC's key-
board to turn off the PTC.
2. Turn off the device the PTC is connected to.
36