Idle-Payload-Fill; Idle-Signal-Fill - Alcatel-Lucent 7750 SR OS Interface Configuration Manual

config>port>tdm>e1
config>port>tdm>e1>channel-group
config>port>tdm>e3
Description
This command configures the value that the HDLC TDM DS-0, E-1, E-3, DS-1, or DS-3 interface
transmits during idle cycles. For ATM ports/channels/channel-groups, the configuration does not
apply and only the no form is accepted.
The no form of this command reverts the idle cycle flag to the default value.
Default
flags (0x7E)
no flags (ATM)
Parameters
flags — Specifies that 0x7E is used as the idle cycle flag.
ones — Specifies that 0xFF is used as the idle cycle flag.

idle-payload-fill

Syntax idle-payload-fill {all-ones}
idle-payload-fill pattern pattern
no idle-payload-fill
Context config>port>tdm>ds1>channel-group
config>port>tdm>e1>channel-group
Description This command defines the data pattern to be transmitted when the circuit emulation service is not
operational or temporarily experiences under-run conditions. This command is only valid for cesopsn
and cesopsn-cas circuit emulation services. It is blocked with a warning for unstructured (satop)
circuit emulation services.
Default all-ones
Parameters all-ones — Defines the 8 bit value to be transmitted as 11111111.
pattern — Transmits a user-defined pattern.

idle-signal-fill

Syntax idle-signal-fill {all-ones}
idle-signal-fill pattern pattern
no idle-signal-fill
Context config>port>tdm>ds1>channel-group
config>port>tdm>e1>channel-group
Description
This command defines the signaling pattern to be transmitted when the circuit emulation service is
not operational or temporarily experiences under-run conditions. This command is only valid for
cesopsn-cas circuit emulation services. It is blocked with a warning for unstructured (satop) and basic
cesopsn circuit emulation services.
7750 SR OS Interface Configuration Guide
Interface Configuration
Page 285