Q-See QC SERIES User Manual page 17

STEP 12. Pull down the "Reset to:"
menu button and select Low
STEP 13. Click the Reset button
STEP 14. Click "Yes" when asked, "Are
you sure you want to change the
setting for this zone?"
STEP 15. Click OK
STEP 16. Click Apply
STEP 17. Click OK
STEP 18. Close Internet Explorer
Open a browser window in Internet Explorer and enter the IP address or DDNS name
(obtained in Section 1.1) into the address bar.
You will see a log in screen similar to that
shown in Picture 2-44 or yellow alert bar at
the top of the window asking for permission
to open an ActiveX application. Allow it to
install webrec.cab control to reach the
sign-in screen.
Proceed to Chapter 3 for instructions on
logging in and remote monitoring.
32
PICTURE 2-42
PICTURE 2-43
PICTURE 2-44
Troubleshooting: User Account Control for Windows Vista and Windows 7
Some users of computers using Windows Vista or Windows 7 operating systems may receive
an error message informing of a codec that is missing or not installed. This conflict can be
resolved by turning off User Account Control (UAC).
Windows Vista
STEP 1. Open the Control Panel
(accessible by clicking on the
Windows icon in the lower left of your
screen.
STEP 2. Select User Accounts and
Family Safety.
STEP 3. Select "Add or Remove User
Account."
STEP 4. Select the desired user account.
STEP 5. Select Turn User Account
Control on or off
PICTURE 2-45
PICTURE 2-46
PICTURE 2-47
PICTURE 2-48
33