Connecting Speakers - Marantz ZR6001 User Manual

CONNECTING SPEAKERS

POWERED
SUBWOOFER
PASSIVE POWER
SUBWOOFER
AMPLIFIER
INVERT INPUT INPUT BTL EXT. CONT. IN REMOTE CONT.
OUTPUT LEVEL
MASTER SLAVE
MIN MAX VIDEO/ SYSTEM OUT OUT IN
+5~13V DC
SPEAKER SYSTEM
MINIMUM 4 OHMS
ANTENNA ANTENNA
Y Y
FM ( ( 75 Ω ) )
FM 75Ω GND GND AM AM
VIDEO VIDEO
TV TV DVD DVD VCR1 VCR1 DSS/VCR2 DSS/VCR2 MONITOR MONITOR
IN IN OUT OUT IN IN OUT OUT OUT OUT
DIGITAL IN DIGITAL IN DIGITAL OUT DIGITAL OUT
3 3 4 4 COAX. COAX.
RS-232C RS-232C
1 1 2 2 OPT. OPT.
TV TV DVD DVD VCR1 VCR1 DSS/VCR2 DSS/VCR2 CD CD
L L
R R
IN IN OUT OUT IN IN OUT OUT
CONNECTING SPEAKER WIRE
1.
Strip away approx. 3/8 inch (10 mm) of wire
insulation.
2.
Twist the bared wire ends tight, to prevent
short circuits.
3.
Loosen the knob by turning it counterclockwise.
4.
Insert the bare part of the wire into the hole in
side of each terminal.
5.
Tighten the knob by turning it clockwise to
secure the wire.
14
or
CENTER
COMPONENT VIDEO COMPONENT VIDEO
MULTI FIXED OUT MULTI FIXED OUT
INPUT-1 INPUT-1 INPUT-2 INPUT-2 MONITOR OUT MONITOR OUT
C C B B / / C C R R / / Y Y C C B B / / C C R R / / Y Y C C B B / / C C R R / /
P P B B P P R R P P B B P P R R P P B B P P R R
L L
1 1
R R
S-VIDEO S-VIDEO
VCR1 VCR1 DSS/VCR2 DSS/VCR2 MONITOR MONITOR
TV TV DVD DVD IN IN OUT OUT IN IN OUT OUT OUT OUT
MULTI MULTI
RC-5 RC-5
RC RC L L SL SL SBL SBL C C
IN IN MODEL NO. ZR6001 MODEL NO. ZR6001
AC IN AC IN
FLASHER FLASHER
PRE PRE PRE PRE
IN IN
OUT OUT OUT OUT
OUT OUT
R R SR SR SBR SBR SW SW SW SW
TAPE TAPE CDR/MD CDR/MD MULTI MULTI L L SL SL SBL SBL C C
R R R R L L L L
7.1CH 7.1CH
IN IN
FRONT FRONT FRONT FRONT CENTER CENTER CENTER CENTER
SPEAKER SYSTEMS : MINIMUM 6 OHMS SPEAKER SYSTEMS : MINIMUM 6 OHMS SPEAKER SYSTEMS : MINIMUM 6 OHMS SPEAKER SYSTEMS : MINIMUM 6 OHMS
IN IN OUT OUT IN IN OUT OUT OUT OUT R R SR SR SBR SBR SW SW
AUDIO AUDIO
( ( AUX2 AUX2) )
RIGHT LEFT RIGHT
FRONT SURROUND
1. 2.
3/8 inch
(10 mm)
3. 4.
Caution:
• Be sure to use speakers with the specified
impedance as shown on the rear panel of this unit.
• To prevent damage to circuitry, do not let the bare
SURROUND
s p e a k e r w i r e s
BACK
touch each other
LEFT
RIGHT
and do not let them
touch any metal
part of this unit.
• Do not touch the
speaker terminals
when the power is
on. It may cause
you to receive an electric shocks.
IR EMITTER OUT IR EMITTER OUT
• Do not connect more than one speaker cable to
2 2 3 3 4 4
one speaker terminal. Doing so may damage this
AC OUTLETS AC OUTLETS
120V 60Hz 120V 60Hz
unit.
Note:
SWITCHED SWITCHED UNSWITCHED UNSWITCHED
1A 120W MAX 1A 120W MAX 1A 120W MAX 1A 120W MAX
• Be sure to connect the positive and negative
cables for the speaker properly. If they are miss-
R R R R L L L L R R R R L L L L
connected, the signal phase will be reversed and
the signal quality will be corrupted.
SURROUND SURROUND SURROUND SURROUND SURROUND BACK SURROUND BACK SURROUND BACK SURROUND BACK
M. SPEAKER B M. SPEAKER B M. SPEAKER B M. SPEAKER B
CONNECTING A SUBWOOFER
Use the PRE OUT SUBWOOFER jack to connect
a powered subwoofer (power amplifier built in).
If your subwoofer is a passive type (power
amplifier is not built in), connect a monaural power
amplifier to the PRE OUT SUBWOOFER jack and
connect the subwoofer to the amplifier.
LEFT
5.