Learn Mode - Marantz SR6300 User Manual

LEARN MODE

The remote controller is capable of learning and memorizing the
remote control codes used by almost any other remote controller you
may already own.
• If no commands have been programmed for a particular function
button, the remote controller will transmit whatever codes have
been factory preset.
• The following example shows how to program your remote
controller and how to use the codes for a DVD player.
LEARNING PROCEDURE
1.
Place the remote controller so that its infrared signal transmitter is
facing the infrared signal receiver on the Marantz remote
controller at a distance of about 5 centimeters.
2.
Press and hold down the T.MODE ⁄1 and MEMO ¤6 buttons until
LEARN is displayed in the display.
3.
Select the function button to select the function.
• Selected function is displayed and LEARN is blinking.
4.
Select the button to be learned.
• LEARN is displayed.
5.
Press and hold the button of the original remote controller to learn
until OK in the display.
• When NG is displayed, repeat this step.
• When FULL is displayed, the memory of the RC7300SR is full.
If you want to learn the code, you should erase other learned
button.
6. 4 5
Repeat steps and to learn other buttons in same function.
7. 3 6
Repeat steps to to learn other function.
8.
When you have finished programming the remote controller,
press and hold down the OK button ⁄5 until USE is displayed in
the display.
Note:
• When NG is displayed in step 5 again, the transmitting code is
unavailable for RC7300SR, or the transmitting signal is
intercepted by noise.
• If no buttons are pressed for approximatelly 1 minutes while in
the LEARN mode, the remote controller automatically returns
to the use mode.
ERASING LEARNING CODE
Erasing the code by buttons
1.
Press and hold down the T.MODE ⁄1 and MEMO ¤6 buttons until
LEARN is displayed in the display.
2.
Select the function button to select the button to be erased.
• Selected function is displayed and LEARN is blinking.
3.
Press and hold down the CL button . and press the learned
button twice to be erased.
• CLR is displayed for 3 seconds and the mode returns to LEARN
mode.
x 2
4.
To return the USE mode, press and hold down the OK button ⁄5
until USE is displayed in the display.
Erasing the code by functions
1.
Press and hold down the T.MODE ⁄1 and MEMO ¤6 buttons until
LEARN is displayed in the display.
2.
Press and hold down the CL button . and press the learned
function button twice to be erased.
• F-CLR and LEARN are blinking.
x 2
3.
Press OK ⁄5 button to continue erasing.
• F-CLR is displayed for 3 seconds and the mode returns to
LEARN mode.
• To cancel the erasing operation, do not press OK button ⁄5
and simply touch any other button.
4.
To return the USE mode, press and hold down the OK button ⁄5
until USE is displayed in the display.
26