Learn Mode - Marantz SR6400 User Manual

LEARN MODE

The remote controll is capable of learning and
memorizing the remote control codes used by
almost any other remote controll you may already
own.
• If no commands have been programmed for a
particular function button, the remote controll
will transmit whatever codes have been factory
preset.
• The following example shows how to program
your remote controll and how to use the codes
for a DVD player.
LEARNING PROCEDURE
1.
Place the remote controll so that its infrared
signal transmitter is facing the infrared signal
receiver on the Marantz remote controll at a
distance of about 5 centimeters.
2.
Press and hold down the T.MODE and MEMO
buttons until LEARN is displayed in the
display.
3.
Select the Function button to select the
function.
• Selected function is displayed and LEARN
is blinking.
4.
Select the button to be learned.
• LEARN is displayed.
5.
Press and hold the button of the original remote
controll to learn until OK is in the display.
• When NG is displayed, repeat this step.
• When FULL is displayed, the memory of the
RC7300SRa is full. If you want to learn this
code, you should erase another learned
button.
6. 4 5
Repeat steps and to learn the other
buttons in the same function.
7. 3 6
Repeat steps to to learn the other function.
8.
When you have finished programming the
remote controll, press and hold down the OK
button until USE is displayed in the display.
Note:
• When NG is displayed in step 5 again, the
transmitting code is unavailable for RC7300SRa,
or the transmitting signal is intercepted by noise.
• If no buttons are pressed for approximately 1
minute while in the LEARN mode, the remote
controll automatically returns to the use mode.
ERASING LEARNED CODES
Erasing the code by buttons
1.
Press and hold down the T.MODE and MEMO
buttons until LEARN is displayed in the
display.
2.
Select the Function button to be erased.
• Selected function is displayed and LEARN
is blinking.
3.
Press and hold down the CL button and press
the learned button twice to be erased.
• CLR is displayed for 3 seconds and the
mode returns to LEARN mode.
x 2
4.
To return to the USE mode, press and hold
down the OK button until USE is displayed in
the display.
Erasing the code by functions
1.
Press and hold down the T.MODE and MEMO
buttons until LEARN is displayed in the
display.
2.
Press and hold down the CL button and press
the learned Function button twice to be
erased.
• F-CLR and LEARN are blinking.
x 2
3.
Press the OK button to continue erasing.
• F-CLR is displayed for 3 seconds and the
mode returns to LEARN mode.
• To cancel the erasing operation, do not
press the OK button and simply touch any
other button.
4.
To return to the USE mode, press and hold
down the OK button until USE is displayed in
the display.
Erasing all functions
1.
Press and hold down the T.MODE and MEMO
buttons until LEARN is displayed in the display.
2.
Press and hold down the CL button and press
POWER ON and POWER OFF button.
• A-CLR and LEARN are blinking.
3.
Press the OK button to continue erasing.
• A-CLR is displayed for 3 seconds and the
mode returns to LEARN mode.
• To cancel the erasing operation, do not
press the OK button and simply touch any
other button.
4.
To return to the USE mode, press and hold
down the OK button until USE is displayed in
the display.
Note:
• Erasing codes will return to the factory preset
codes, or it will be empty if the button has no
factory preset code.
29