Ip Igmp Snooping Vlan Mrd - Motorola EX-3524 Cli Reference Manual

ip igmp snooping vlan
mrd
Default Setting
10 (1 second)
Command Mode
Global Configuration
Command Usage
◆
When a multicast host leaves a group, it sends an IGMP leave message. When
the leave message is received by the switch, it checks to see if this host is the
last to leave the group by sending out an IGMP group-specific query message,
and starts a timer. If no reports are received before the timer expires, the group
record is deleted, and a report is sent to the upstream multicast router.
◆
A reduced value will result in reduced time to detect the loss of the last
member of a group or source, but may generate more bursty traffic.
◆
This command will take effect only if IGMP snooping proxy reporting is enabled
(page 461).
Example
Console(config)#ip igmp snooping vlan 1 last-memb-query-intvl 700
Console(config)#
This command enables sending of multicast router solicitation messages. Use the
no form to disable these messages.
Syntax
[no] ip igmp snooping vlan vlan-id mrd
vlan-id - VLAN ID (Range: 1-4093)
Default Setting
Enabled
Command Mode
Global Configuration
Command Usage
◆
Multicast Router Discovery (MRD) uses multicast router advertisement,
multicast router solicitation, and multicast router termination messages to
discover multicast routers. Devices send solicitation messages in order to solicit
advertisement messages from multicast routers. These messages are used to
discover multicast routers on a directly attached link. Solicitation messages are
also sent whenever a multicast forwarding interface is initialized or re-
initialized. Upon receiving a solicitation on an interface with IP multicast
forwarding and MRD enabled, a router will respond with an advertisement.
Chapter 20
– 471 –
| Multicast Filtering Commands
IGMP Snooping