Headlamp High/Low-Beam; Flash-To-Pass; Daytime Running; Lamps (Drl) - Chevrolet 2014 TRAX Owner's Manual

6-2 Lighting
Headlamp High/
Low-Beam Changer
3

(Headlamp High/Low-Beam

Changer): Push the turn signal
lever away from you and release, to
turn the high beams on.
To return to low beams, push the
lever again or pull it toward you and
release.
This indicator light turns on in the
instrument cluster when the
high-beam headlamps are on.

Flash-to-Pass

To flash the high beams, pull the
turn signal lever all the way toward
you. Then release it.

Daytime Running

Lamps (DRL)

If equipped with DRL, they make it
easier for others to see the front of
your vehicle during the day. Fully
functional daytime running lamps
are required on all vehicles first sold
in Canada.
A light sensor on top of the
instrument panel makes the DRL
work, so be sure it is not covered.
The DRL system makes the
low-beam headlamps come on at a
reduced brightness when the
following conditions are met:
The ignition is in the ON/
RUN mode.
The exterior lamp control is
in AUTO.
The engine is running.
When the DRL are on, only the
low-beam headlamps, at a reduced
level of brightness, will be on. The
taillamps, sidemarker, instrument
panel, and other lamps will not
be on.
The headlamps automatically
change from DRL to the regular
headlamps depending on the
darkness of the surroundings. The
other lamps that come on with the
headlamps will also come on.
When it is bright enough outside,
the headlamps go off and the DRL
come on.
To turn the DRL off or on again, turn
the exterior lamp control to the off
position and then release. For
vehicles first sold in Canada, the
DRL cannot be turned off.