Post Codes; Ami Post Codes - EVGA Z170 STINGER User Manual

EVGA Z170 STINGER (111-SS-E172)

POST Codes

This section provides the AMI POST Codes for the
EVGA Z170 Dark Motherboard during system boot
up.
The POST Codes are displayed on the Debug LED
readout located directly onboard the motherboard.
This Debug LED will also display current CPU
temperatures after the system has fully booted
into the Operating System.

AMI POST Codes

01 Power on. Reset type detection (soft/hard).
02 AP initialization before microcode loading
03 North Bridge initialization before microcode loading
04 South Bridge initialization before microcode loading
05 OEM initialization before microcode loading
06 Microcode loading
07 AP initialization after microcode loading
08 North Bridge initialization after microcode loading
09 South Bridge initialization after microcode loading
0A OEM initialization after microcode loading
0B Cache initialization
0C-0D Reserved for future AMI SEC error codes
0E Microcode not found
0F Microcode not loaded
10 PEI Core is started
11-14 Pre-memory CPU initialization is started
15-18 Pre-memory North Bridge initialization is started
19-1C Pre-memory South Bridge initialization is started
1D-2A OEM pre-memory initialization codes
2B Memory initialization. Serial Presence Detect (SPD) data
reading
2C Memory initialization. Memory presence detection
2D Memory initialization. Programming memory timing
Debug LED with CPU
Temperature Monitor
- 32 -