Troubleshooting; General; Disc Playback - Marantz CC4003 User Manual

TROUBLESHOOTING

If you have any problem using this product, please be sure to check the items in the following table.
If you trouble cannot be solved, please unplug the power cord immediately and contact your Marantz authorized dealer or service center.

GENERAL

Symptom Cause
The AC power cord is not properly
No power.
connected.
The output cables are not fi rmly
connected.
The analog outputs of this unit are
No sound or
connected with the PHONO input
distorted sound.
connectors of the amplifi er.
Improper amplifi er operation.
Playback of this unit is paused.
The headphones plug is not fi rmly
No sound from
connected.
the connected
headphones or
The headphones level is set to the
distorted sound.
minimum.
No digital audio The digital connecting cables are
output. not fi rmly connected.
The batteries of the remote
controller are exhausted.
The remote controller is located
outside its operable range.
This unit cannot
be controlled Some object is placed between
with the remote the unit and remote controller.
controller.
The remote sensor of the unit is
exposed to strong light.
The EXTERNAL/INTERNAL
switch on the rear panel is set to
EXTERNAL.
Solution Page
Plug the AC power cord fi rmly into
6
the unit.
Plug the AC power plug fi rmly into
6
a wall outlet.
Connect the output cables fi rmly
into the connectors of this unit and 6
the amplifi er.
Do not connect the analog outputs
of this unit with the PHONO input 6
connectors of the amplifi er.
Confi rm the input selection, audio
volume adjustment, and speaker 6
settings of the amplifi er.
Press the Play button. 7
Insert the headphones plug fi rmly
into the headphones jack of this 4
unit.
Adjust the headphones level. 4
Securely connect the digital
8
connecting cables.
Replace with new batteries. 3
Check the operable range of the
remote controller and use it within 3
that range.
Remove the object. 3
Avoid exposing the remote sensor
3
to the strong light.
Set the EXTERNAL/INTERNAL
6
switch to INTERNAL.

DISC PLAYBACK

Symptom Cause
The disc is not loaded properly in
the tray.
The disc is placed upside-down.
(The label of the disc is facing
down.)
The disc is dirty.
No playback with The disc is scratched.
a disc.
The disc is warped.
A disc that is not supported by this
unit is attempted to be played.
Condensation has formed on the
lens inside this unit.
The disc has not been fi nalized.
No playback with
The recorded data are not in CDDA
a CD-R/CD-RW
format for music. Or, an MP3/
disc.
WMA fi le has not been recorded
properly.
ENGLISH
Solution Page
Load the disc properly. 7
Place the disc with its label facing
7
upward.
Clean the disc's surface. 16
A disc with many scratches may
16
not be playable.
The disc may be unable to be
16
played if it is badly warped.
Use a disc that is supported by
14
this unit.
Turn on the unit then wait for
about 30 minutes before turning it 2
back on again and using it.
Perform fi nalization of the disc,
14
using writing software.
Record data in a proper format
14
supported by this unit.
13