Table of Contents
Advertisement
2
2
.
.
3
3
P
P
r
r
o
o
c
c
e
e
s
s
s
s
o
o
r
r
The server blade uses AMD
800MHz Hyper Transport Bus.
The location of the processor on the motherboard is shown as below:
You can install single or dual processors on the board according to your own needs. Please refer to the
following points before the installation:
1. If SINGLE processor is intended, always install the processor on the processor 1 socket and for the
location of processor 1 and processor 2, please refer to the above figure.
2. If install DUAL processors, you must install processor 1 first and use the same type of processor
running at the same identical revision, core voltage and bus/core speed.
Important: Before you install or remove the processor, please see "2.1 Before You
Start".
Important: Processor module contains the heat sink and the processor. To remove the
Processor module, please remove the heat sink first, then, remove the processor from the
system board.
1230B0015201
®
Opteron™ 200 series processors in 940-pin mPGA sockets with
Figure 2-5 Processor Location
Processor 1
Processor 2
Hardware Operation
2-4
Advertisement
Table of Contents
