Disassembly Method - JVC XV-S62SL Service Manual

XV-S62SL

Disassembly method

<Main body>
Removing the top cover (see Fig.1)
1.Remove the two screws A attaching the top cover
on both sides of the body.
2.Remove the three screws B attaching the top cover
on the back of the body.
3.Remove the top cover from the body by lifting the
rear part of the top cover.
ATTENTION: Do not break the front panel tab
fitted to the top cover.
Removing the mechanism assembly
* Prior to performing the following procedure, remove
the top cover.
* There is no need to remove the front panel assembly.
1.Remove the three screws C attaching the mechanism
assembly on the bottom chassis.
2.The servo control board is removed from the connector
CN512 and CN513 connected with the main board
respectively.
3.Remove the mechanism assembly by lifting the rear part
of the mechanism assembly.
Removing the servo control board
* Prior to performing the following procedure, remove
the top cover and mechanism assembly.
1.Disconnect the card wire from connector CN201 and
CN202 on the servo control board respectively.
2.Disconnect the flexible wire from connector CN101
on the servo control board from pick-up.
ATTENTION
At this time, please extract the wire after short-circuited
of two places on the wire in part a with solder.
Please remove the solder two places of part a after
connecting the wire with CN101 when reassembling.
3.Two places in hook b are removed, the servo control board
is lifted, and it is removed.
1-6
(see Fig.2,3)
(see Fig.4)
A x 2
B
Fig.2
Mechanism assembly
CN513
Main board
Fig.3
Hook b
Fig.4
B
B
Fig.1
Servo control
CN512
board
Hook b
Servo control
board