Lincoln Electric FLEXTEC 500 P Operator's Manual page 28

FLEXTEC™ 500 P
POWER-UP SEQUENCE
ELECTRIC SHOCK can kill.
UNLESS USING COLD FEED FEATURE, WHEN
FEEDING WITH GUN TRIGGER, THE ELEC-
TRODE AND DRIVE MECHANISM ARE
ALWAYS ELECTRICALLY ENERGIZED AND
COULD REMAIN ENERGIZED SEVERAL
SECONDS AFTER THE WELDING CEASES.
--------------------------------------------------------
FUMES AND GASES can be
dangerous to your health.
• Keep your head out of fumes.
• Use ventilation or exhaust to remove
fumes from breathing zone.
--------------------------------------------------------
WELDING SPARKS can cause fire or
explosion.
• Keep flammable material away.
• Do not weld on closed containers.
--------------------------------------------------------
ARC RAYS can burn eyes and skin.
• Wear eye, ear and body protection.
• SEE ADDITIONAL WARNING INFORMATION UNDER
"ARC WELDING SAFETY PRECAUTIONS" ON INSIDE
OF FRONT COVER OF OPERATING MANUAL.
--------------------------------------------------------
When power is applied to the Flextec™ 500 P, the displays will
illuminate and the machine electronics will complete a power up
sequence indicated by a scrolling bar across each seven segment
display. Once the power up sequence if complete and the machine
is ready for welding, the seven segment displays will indicate the
voltage and amperage settings. Any ArcLink wire feeders present
and connected to the 5-pin circular connector will also initialize
and begin a power up sequence once power is applied to the
machine.
WARNING
C-2
OPERATION