JVC XV-FA90BK Service Manual page 9

Removing the rear panel (See Fig.12)
Prior to performing the following procedure, remove
the top cover.
1. Remove the fourteen screws F attaching the rear
panel.
Removing each board (See Fig.13,14)
Prior to performing the following procedure, remove
the top cover, the front panel assembly, the main
tray assembly, rear panel and the loading base
assembly.
Surround audio board
1. Pull out the surround audio terminal board from
connector CN763.
2. Remove the screw G attaching the surround audio
board.
3. Pull out the surround audio board from connector
CN754 and CN603.
Servo control board
1. Pull out the relay board 2 on the upper side of the
body.
2. Disconnect the wire from connector CN807, CN810
and CN901 on the servo control board respectively.
3. Remove the screw I attaching the lug wire.
4. Remove the three screws H attaching the servo
control board.
Relay board 1
1. Disconnect the wire from connector CN842 on the
relay board 1.
2. Remove the two screws I attaching the relay board.
A/V output board
1. Pull out the relay board 2 on the upper side of the body.
2. Remove the four screws J attaching the A/V output
board.
Power board
1. Disconnect the wire from connector CN952 and
CN953 on the power board.
2. Remove the four screws K on the upper side of the
body.
XV-FA90BK/XV-FA92SL/XV-FA95GD
F F
F
Fig.12
Relay board 2
Lug wire
Relay board 1
Power
board
I
CN842
H
Fig.13
K
Power board
K
CN952
CN953
Relay board 1
Fig.14
F
F
Rear panel
Surround audio
terminal board
CN763
CN754
A/V output board
G
H
CN603
Surround audio board
Servo control
board
H
CN901
CN807
CN810
A/V output board
J
J
Relay board 2
Servo control
board
1-9