Operating The Appliance - VINCENT SV-500 Instructions For Use Manual

Operation
Switch on and off
Select an input
Change the volume
Mute the speakers and
the preamplifier output
Change the treble pro-
portions of the sound

OPERATING THE APPLIANCE

Button(s) Description
The amplifier is switched on and off using this button at the front panel,
there is no standby option. When switched off the device is internally sepa-
rated from the AC power. When switched on, one of the LED's near the
POWER (1)
input selector (1) is lit. As a precaution, before switching on, the volume set-
ting (8)(21) should be reduced. The switching operation is signalled via the
cables connected in the terminal "POWER CONTROL" (14).
On the front panel: if the "INPUT" dial is turned clockwise or in the opposi-
te direction, each of the input channels will be selected in turn and this swit-
ches the playback between the devices connected to the corresponding
INPUT (2)
input sockets (10). The relevant LED lit over the "INPUT" selection dial
shows which source is currently selected.
Input
Using the remote control: A short touch on the button for the desired input
selector
channel (e.g. "S1" changes to the playback of the audio source connected
buttons
there.
(20)
The illuminated LED near the input selector (2) indicates which audio source
is currently selected for playback. Before switching over the input channel,
the volume (8)(21) should be turned down as a precaution!
On the front panel: Turn the knob "VOLUME" clockwise to turn up the volu-
me and counter-clockwise to turn it down.
Using the remote control: Hold down the button "VOLUME
VOLUME (8)
volume up. Use "VOLUME
The volume setting affects the signals for the loudspeakers and additional
VOLUME
main amplifier channels (13) but never influences the signal at the output
p q
/
"REC OUT" (11). If a pair of headphones is plugged into the front of the
(21)
device, the volume control no longer affects the loudspeakers but instead
affects these headphones.
The MUTE function can only be operated with the remote control. It swit-
MUTE (9) ches off the loudspeakers, the headphones, the preamplifier output "PRE
OUT" (13) and the recording output "REC OUT" (11). Pressing it again
restores the volume to its original setting.
With the "TREBLE" control dial on the front of the device you affect the pro-
portion of higher frequencies in the sound. Turning it in clockwise direction
increases the treble intensity and moving it in anticlockwise direction redu-
ces it. In the middle setting the treble proportions of the input signals remain
TREBLE (6)
unchanged. The adjustment of the treble control only has an effect if the
button "TONE" (5) has been pressed. This tone control affects the loud-
speaker and headphone signals as well as the output "PRE OUT" (13).
The signal of the output "REC OUT" (11) is independent of this.
q
" to turn it down.
p
" to turn the
Vincent
37