Operating The Appliance - VINCENT SV-700 Instructions For Use Manual

Operation
Switch on and off
Select an input
Change the volume
Select amplifier mode
Individually activate or
deactivate speaker out-
puts A and B
Vincent
42

OPERATING THE APPLIANCE

Button(s) Description
The amplifier is switched on and off using this button at the front panel,
there is no standby option. When switched off the device is internally sepa-
rated from the AC power. When switched on, one of the LED's near the
POWER (6)
input selector (1) is lit. As a precaution, before switching on, the volume set-
ting (2)(20) should be reduced. The switching operation is signalled via the
cables connected in the terminal "POWER CONTROL" (13).
On the front panel: if the "INPUT" dial is turned clockwise or in the opposi-
te direction, each of the input channels will be selected in turn and this swit-
ches the playback between the devices connected to the corresponding
INPUT (1)
input sockets (11). The relevant LED lit over the "INPUT" selection dial
shows which source is currently selected.
Input
Using the remote control: A short touch on the button for the desired input
selector
channel (e.g. "S1" changes to the playback of the audio source connected
buttons
there.
(18)
The illuminated LED near the input selector (1) indicates which audio source
is currently selected for playback. Before switching over the input channel,
the volume (2)(20) should be turned down as a precaution!
On the front panel: Turn the knob "VOLUME" clockwise to turn up the volu-
me and counter-clockwise to turn it down.
Using the remote control: Hold down the button "VOLUME
VOLUME (2)
volume up. Use "VOLUME
The volume setting affects the signals for the loudspeakers and additional
VOLUME
main amplifier channels (9) but never influences the signal at the output
p q
/
"REC OUT" (10). If a pair of headphones is plugged into the front of the
(20)
device, the volume control no longer affects the loudspeakers but instead
affects these headphones.
This button toggles between Class A and Class AB modes. In this way you
can switch from the better sounding Class A mode to the energy-saving
CLASS A /
Class AB mode with less waste heat, for instance for sound reproduction for
CLASS AB (3)
a party, where absolute high fidelity is not necessary. It is allowed to use
this switch even while music is being played back.
To play back music at least one loudspeaker must be attached to the ampli-
SPEAKER A
fier (a practical choice would be connectors "A"). The output you use must
SPEAKER B
be activated using the corresponding button "SPEAKER" (LED illuminated).
(7)
Only if a second speaker is used, it is necessary to activate the second
speaker output "B".
q
" to turn it down.
p
" to turn the