Climate Controls; Climate Control System - Chevrolet 2008 Optra Owner's Manual

Climate Controls

Climate Control System

The heating, cooling and ventilation for your vehicle can
be controlled with this system.
Uplevel shown, Base similar
9
(Fan): Turn the left knob clockwise or
counterclockwise to increase or decrease the fan speed.
In any setting other than off, the fan runs continuously
with the ignition in ON/RUN. The fan must be on for the
air conditioning compressor to run.
To change the current mode, select one of the following
from the middle knob:
E
(Vent): This mode directs air to the instrument
panel outlets.
(
(Bi-Level): This mode splits the air between the
instrument panel outlets and the floor outlets.
5
(Floor): This mode directs most of the air to the floor
outlets. Some of the air will also be directed to the
windshield, instrument panel side outlets, and the rear
outlets. Be sure to keep the area under the front seats
clear to allow the flow of air to the rear compartment.
Temperature Control: Turn the right knob clockwise or
counterclockwise to manually increase or decrease the
temperature inside the vehicle. Turn the knob to the blue
area to get cool air and to the red area to get warm air.
A/C (Air Conditioning): If your vehicle has air
conditioning, follow these steps to use the system.
Start the engine and set the fan control knob to
the desired fan speed. The air conditioning compressor
does not operate when the fan control knob is turned
to OFF. Press the A/C button to turn the air conditioning
system on and off. When A/C is pressed, an indicator
light in the button comes on to show that the air
conditioning is activated.
3-19