Using An External Display - Panasonic CF-27 Series Toughbook Reference Manual

Using an External Display

The optional port replicator (
adapter (CF-VEB274) is required for use with an external display.
1
Power off your computer
Do not shut down using the suspend or hibernation mode.
2
Connect the external display
NOTE
For more detailed information, refer to the operation manual of the
port replicator, the external display port adapter or the external dis-
play.
3
Turn on the external display, then turn on your computer
with the display opened and make settings during start-up
You can select either an external display, LCD or simultaneous with Fn
+ F3 . In addition, you can set the display to use during start-up with the
following procedure.
1
Run the Setup Utility
2
Using and
3
Using and
4
Using and
Enter
5
Press F10 , then select [Yes]
6
Windows 95
Select your external display
Set your external display for [Monitor] in [Start] - [Settings] - [Control
Panel] - [Display] - [Settings] - [Advanced Properties].
When a monitor that does not conform to the Plug & Play standards
is connected, select [Change] and make the monitor settings.
page 35) or the external display port
( "Starting Up/Shutting Down")
( page 44)
, select [Main]
, select [Display] and press Enter
, select the display to use and press
37