Mercedes-Benz CLS 2015 Operator's Manual page 387

approved antenna positions
Front roof area
:
Rear roof area
;
Rear fender
=
Trunk lid
?
i When installing an antenna on the front
roof area of vehicles with a sliding sunroof,
observe the sweeping range of the roof.
On the rear fenders, it is recommended to
position the antenna on the side of the
vehicle closest to the center of the road.
Use the Technical Specification ISO/TS
21609 when retrofitting RF transmitters
(Road Vehicles - EMC guidelines for installa-
tion of aftermarket radio frequency transmit-
ting equipment). Observe the legal require-
ments for retrofittings.
If your vehicle has installations for two-way
radio equipment, use the power supply or
antenna connections intended for use with
the basic wiring. Be sure to observe the man-
ufacturer's additional instructions when
installing.
Deviations with respect to wavebands, maxi-
mum transmission outputs or antenna posi-
tions must be approved by Mercedes-Benz.
Vehicle electronics
The maximum transmission output (PEAK) at
the base of the antenna must not exceed the
following values:
Waveband
Short wave
3 - 54 MHz
4 m waveband
74 - 88 MHz
2 m waveband
144 - 174 MHz
Trunked radio/Tetra
380 - 460 MHz
70 cm waveband
400 - 460 MHz
Mobile communications
(2G/3G/4G)
The following can be used in the vehicle with-
out restrictions:
RF transmitters with a maximum transmis-
R
sion output of up to 100 mW
RF transmitters with transmission frequen-
R
cies in the range 380-410 MHz and a max-
imum transmission output of 2 W (Tetra)
Mobile telephones (2G/3G/4G)
R
There is no restriction for antenna positions
on the outside of the vehicle for the following
wavebands:
Trunked radio/Tetra
R
70 cm waveband
R
Mobile communications (2G/3G/4G)
R
385
Maximum
transmission
output
100 W
30 W
50 W
10 W
35 W
10 W
Z