Blind Spot Assist - Mercedes-Benz CLS 2015 Operator's Manual

Driving systems
214
You can have current status information dis-
played in the assistance menu (
of the on-board computer.
Select the Assistance display for ATTEN-
X
TION ASSIST using the on-board computer
( page 235).
Y
The following information is displayed:
length of the journey since the last break.
R
the attention level determined by ATTEN-
R
TION ASSIST, displayed in a bar display in
five levels from high to low.
if ATTENTION ASSIST is unable to calculate
R
the attention level and cannot output a
warning, the
appears. The bar display then changes the
display, e.g. if you are driving at a speed
below 37 mph (60 km/h) or above 124 mph
(200 km/h).
Activating ATTENTION ASSIST
Activate ATTENTION ASSIST using the on-
X
board computer (
The system determines the attention level
of the driver depending on the setting
selected:
Standard selected: the sensitivity with
which the system determines the attention
level is set to normal.
Sensitive selected: the sensitivity is set
higher. The attention level detected by Atten-
tion Assist is adapted accordingly and the
driver is warned earlier.
When ATTENTION ASSIST is deactivated, the
À symbol and OFF appear in the multi-
function display in the assistance display
when the engine is running.
When ATTENTION ASSIST has been deactiva-
ted, it is automatically reactivated after the
engine has been stopped. The sensitivity
selected corresponds to the last selection
activated (standard/sensitive).
page 235)
Y
System Suspended System Suspended message
page 236).
Y
Warning in the multifunction display
If fatigue or increasing lapses in concentra-
tion are detected, a warning appears in the
multifunction display:
Take a Break! Take a Break!
In addition to the message shown in the mul-
tifunction display, you will then hear a warn-
ing tone.
If necessary, take a break.
X
Confirm the message by pressing the a
X
button on the steering wheel.
On long journeys, take regular breaks in good
time to allow yourself to rest properly. If you
do not take a break, you will be warned again
after 15 minutes at the earliest. This will only
happen if ATTENTION ASSIST still detects
typical indicators of fatigue or increasing lap-
ses in concentration.
Vehicles with COMAND: if a warning is
issued in the multifunction display, a service
station search is performed in COMAND. You
can select a service station and navigation to
this service station will then begin. This func-
tion can be activated and deactivated in
COMAND.
Lane Tracking package
General notes
The Lane Tracking package consists of Blind
Spot Assist ( page 214) and Lane Keeping
Y
Assist ( page 216).
Y

Blind Spot Assist

General notes
Blind Spot Assist uses a radar sensor system
to monitor the areas on both sides of your
vehicle. It supports you from a speed of
approximately 20 mph (30 km/h). A warning
display in the exterior mirrors draws your
attention to vehicles detected in the moni-
tored area. If you then switch on the corre-
sponding turn signal to change lanes, you will
also receive an optical and audible collision
Attention Assist: Attention Assist: