Nikon D70 VBA10401 Repair Manual page 72

CCD PCB unit
・ Attach the CCD dust-proof seal (#56).
・ Assemble the CCD PCB unit (#B3031) with
4 screws (#669).
＊ Note ①：
In case there are washers inserted between the
rear body and the CCD PCB unit, follow the
instructions of Page A23.
＊ Note ②：
In case spacers are attached at A parts of the CCD
PCB unit, mount the CCD PCB unit without
removing them.
（ Red mark is indicated on the attachment surface.)
If there are no indications at A parts, spacers are
unnecessary.
・ Attach the CCD PCB connection harness to the connector.
Memory compression PCB
・ Assemble the memory compression PCB (#B2033) and attach it with 4 screws (#679).
・ Attach the USB gasket (#B481) on the memory compression PCB.
・ Put the ferrite core (#1133) on I/F PCB connection FPC.
・ Connect the connection FPCs, which are connected from CF PCB, I/F PCB, main PCB, and CCD PCB to
each connector.
CF PCB connection FPC
#B3031
I/F PCB connection FPC
#B2033
#679×4
- Ａ41 ･
Direction for
#669×4
positioning
CCD PCB connection harness
＊ Main PCB connection FPC
#1133
When adjusting camera body, re-
move this FPC. ref. Page A35.
#B481
CCD PCB connection FPC
-
VBA10401-R.3623.A
A parts
#56