Epson EMP-TW1000 Service Manual page 83

When installing the MA-IF Board Assy., pay attention to the following
C A U T I O N
instructions.
1). Twist the TH Board Assy. Cable and Exhaust Fan; B Cable around the
Power Cable, then secure the cables by putting them into the space by the
Exhaust Duct as shown in Figure 4-16.
2). Route the LV Thermistor Cable as shown in Figure 4-17, and secure it with
heat-resistant tape.
SEIKO EPSON
EMP-TW1000
TH Board Assy. Cable
The space by the duct
LV Thermistor Cable
Figure 4-16.
heat-resistant tape
Figure 4-17.
4-21
Exhaust Fan Cable
Power Cable
Revision:A